Hardware, software and integration
Hardware
Board-level design of drivers, controllers and data distribution, from the power stage through the protection to the I/O. Where an existing product does not fit the application, the electronics are adapted or designed for it.
Embedded firmware
The firmware on our devices is our own, so behaviour can be changed where an application needs it: control modes, timing, thresholds, how a fault is handled. Not configuration alone — the code itself.
Application software and APIs
Configuration, monitoring and control run through our own software and an open API. That API is the integration point: read-out and control from a PLC, a SCADA layer, a machine controller or a customer’s own application.
Integration
Existing installations rarely start from a clean sheet. We work from the interfaces that are already there — protocols in use, signals available at the cabinet, the controller that stays — and build towards them rather than around them.
Working with us
Most requests reach us as a requirement rather than a specification: an application that has to be lit in a particular way, within an installation that is already defined. Establishing what that means at the terminal block and at the interface is the first part of the work.